GE Profile PV977 Manual Del Propietario E Instrucciones De Instalación página 23

STEP 7 DETERMINE DUCT LENGTH
AND INSTALL DUCT
• Measure from the hood exhaust opening to
the top of the supports as shown in the figure.
• Subtract the height of the air deflector.
• Cut the 8" duct to the appropriate length. Attach
to air deflector using aluminized tape and screws.
Installation Instructions
Length of duct
needed minus the
length protruding
through the ceiling.
23
STEP 8 INSTALL HOOD ASSEMBLY
TO CEILING SUPPORT
WARNING:
to lift and position the hood onto the support.
• Carefully lift the hood assembly to the ceiling
support. The clips on the ceiling support will snap
into the openings on the vertical supports.
• Slip the duct over the exhaust opening.
• Using the screws provided, attach the upper
vertical supports to the ceiling support, 2 screws
per side for a total of 16 screws.
• Seal the air duct to the exhaust opening using
aluminized duct tape.
Clips
Two people are required
Ceiling
support
Air
deflector
Tape with
aluminized
duct tape