Flama 1706 FL Manual De Usuario página 42

Never immerse the block motor (1) in water, or any other liquid for that matter.
Never wash the motor block (1) in the dishwasher (fig. M).
• Apart from the motor block (1), every other attachment can be washed in lukewarm
water with standard washingup liquid.
Apart from the motor block (1),the above attachments are totally dishwasher-safe,
provided the temperature does not exceed 65°C (fig. M).
Blades (3 and 1 1) are sharp, handle them with the utmost care.
• Ingredients may sometimes leave colour marks on the appliance attachments (for
instance, streaks of orange after cutting carrots), which can be easily removed by
dipping a cloth into edible oil.
Before re-connecting the plug into the power socket, make sure the appliance and
all its corresponding attachments are perfectly dry.
FOR UK ONLY
The wires in the mains lead are coloured in accordance with the following code.
• Blue – NEUTRAL
• If your appliance is fitted with a nonrewireable mains plug which is not suitable for
the socket outlets in your home, the plug must be cut off and an appropriate one
fitted.
NOTE:
• A plug cut off from a flexible cord will give a shock hazard if inserted in a 13 amp
socket elsewhere in the house. To avoid this, it should be disposed of immediately.
• If you are fitting an alternative type of plug then the colours of the wires in the mains
lead of the appliance may not correspond with the coloured markings identifying the
terminals on your plug. In this case proceed as follows:
- The wire which is coloured BLUE must be connected to the terminal which is
marked with the letter N or coloured BLACK.
- The wire which is coloured BROWN must be connected to the terminal which is
marked with the letter L or coloured RED.
NOTE:
• For your addotional safety, the appliance has been double insulated and must not
be earthed.
• Therefore do not connect either of the wires to the earth terminal of the three pin
plug.
• If a 13 amp (BS1363) plug is used a 13 amp (BS 1362) fuse must be fitted either in the
plug, adaptor or at the fuse board.
NOTE:
• The fuse cover of a non-rewireable plug must be refitted when changing the fuse.
Should the fuse cover become lost, the plug must not be used until the correct
replacement fuse cover is obtained from our service department or stockist.
Brown – LIVE.
40