PowerStroke PS906811PA Serie Manual Del Operador página 22

USING THE BATTERY MAINTAINER
See Figure 22.
When storing the generator, the battery maintainer can be
connected to keep the battery fully charged and ready for use.
NOTE: The battery maintainer provided should only be used
with the 12V 9Ah/20HR lead acid battery model RT1290H
supplied with this generator.
 Connect the battery maintainer to the power supply. Make
sure the power supply is normal household voltage, 120
volts, AC only, 60 Hz.
 Attach the other end of the battery maintainer to the
charging cable attached to the battery. The red light on
the plug will illuminate to show the battery is charging.
The battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
When battery is fully charged, the red light will turn green.
NOTE: If the light does not illuminate, the fuse on the
charging cable may need to be replaced. Check the fuse
and replace if needed.
 Disconnect the battery maintainer before operating the
generator. Place the cover on the charging cable when
not in use.
MAINTENANCE
BATTERY REMOVAL AND PREPARATION
FOR RECYCLING
Consult your local waste authority for information regarding
available recycling and/or disposal options.
Upon removal, cover the battery's terminals with heavy-duty
adhesive tape. Do not attempt to destroy or disassemble
battery or remove any of its components. Lead acid batter-
ies must be recycled or disposed of properly. Also, never
touch both terminals with metal objects and/or body parts
as short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/or
serious injury.
Page 18 — English
To preserve natural resources, please recycle
or dispose of batteries properly.
This product uses lead acid batteries. Local,
state or federal laws may prohibit disposal of
batteries in ordinary trash.
WARNING: