Pressure Washer Rinsing; Automatic Cool Down System - Briggs & Stratton GENERAC 2300PSI Owner’s Manual

Ocultar thumbs Ver también para GENERAC 2300PSI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

bye&
S_on
_
_
POWER p_UC rs
, Hake sure the garden
hose is connected
to the water
inHet. Check that the hgh pressure hose is connected to
the spray gun and the pump. Start the engine.
° AppHy the detergent to a dry surface, starting at lower
portion
of area to be washed and work upward, using
Hong,even, overlapping
strokes.
° AHHowthe detergent to "soak in" for 3-5 minutes before
washing and rinsing. ReappHyas needed to prevent
surface from drying. Do Not
allow the detergent to dry
on (prevents streaHdng).
mMPORTANT:You
must flush the chemicaH injection
system after each use by pHacingthe fiHter into a bucket of
dean water, then run the pressure washer in How pressure
for H=2minutes.
Pressure
Washer
Rinsing
WARNING!
Be extremeHy carefuH if you must
use the pressure washer from a Hadder,scaffoHding
or any other relatively unstabHe Hocation. Pressure in
a running washer buiHds as you cHimb.When you
press the trigger, the recoiH from the initiaH spray
couHd cause you to fall.The high pressure spray
couHd aHso cause you to fall if you are too chose to
the cHeaning surface.
For Rinsing:
, SHidethe nozzHe backward to high pressure and press the
trigger. It wiHH take a few seconds for the detergent to
clear.
NOTE:You
can aHso stop detergent from flowing by simpHy
removing detergent siphon tube from botde.
, Keep the spray gun a safe distance from the area you
pHan to spray.
" AppHy a high pressure spray to a smaHH area, then check
the surface for damage. If no damage is found, it is okay
to continue rinsing.
° Start at the top of the area to be rinsed, working
down
with same overHapping strokes as you used for cHeaning.
Automatic
Cool Down System
(Thermam
Remief}
If you run the engine on your pressure washer for
3=5 minutes without
pressing the trigger on the spray gun,
circuHating water in the pump can reach a temperature
between
H25°-H 55°EWhen
the water reaches this
temperature,
the automatic
cool down system engages and
cooHs the pump by discharging
the
warm
water
onto
the ground.
This system
prevents
internaH damage to the
pump.
SPECRFRCATRONS
Rated
Pressure
.....
2,300 psi
Flow Rate
..........
2.0 gaHHonsper minute
(gpm)
Detergent
..........
Use detergent approved for
pressure washers
Water
SupplyTemp
. Not to exceed
H00°F
Automatic
Cool
....
VViHH cycHewhen water
Down
System
.......
reaches
H 25 °° H 55°F
Shipping
Weight
....
77 Hbs.
II

Publicidad

Tabla de contenido
loading

Tabla de contenido