Briggs & Stratton GENERAC 2300PSI Owner’s Manual página 5

bye& S_on _
_ POWER p _r_UC rs
iMPORTANT: Read entire owner's manuaH before you
attempt to assembie or operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
o Remove the parts bag, accessories, and insert inciuded
with pressure washer.
o Siice two corners at the end of carton from top to
bottom so the panei can be foided down flaL then
remove ali packing material
o Roli pressure washer out of carton.
Carton Contents
Items in the carton include:
Hain Unit
Goggies
Handie
Piastic Accessory Tray
High Pressure Hose
Spray Gun
Nozzie Extension
Oil Bottle
Parts Bag (which inchdes the following):
Owner's Planual
Engine Planual
Owner's Registration Card
Plaintenance Kit
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"J" Hook
Chemical Hose Clip
Self Tapping Screws (5)
ff any of the above parts are missing or damage& cail the
pressure washer heipiine at 1-800-270-[ 408.
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damage& cail the
pressure washer heipiine at [ -800-270- [ 408.
To prepare your pressure washer for operation,
you
wi[[ need to perform these tasks:
o Fiil out and send in registration card.
o Attach accessory tray to handie_ then attach handle to
main unit.
o Add oi[ to engine crankcase.
o Add fuel to fuel tank.
o Connect high pressure hose to spray gun and pump.
o Connect water supply to pump.
Attach Handle and Accessory Tray
NOTE: AHH assembiy operations given in this section wiHH be
described from the perspective of assembling the pressure
washer from the rear.
o Slide the plastic accessory tray onto the handle and align
the holes in the accessory tray with the holes on the
handle (Figure I).
o Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
5