Briggs & Stratton GENERAC 2300PSI Owner’s Manual página 8

Ocultar thumbs Ver también para GENERAC 2300PSI:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

b
Y_&_
$_ra_on'
_
powE_ _ODUCT_
NOWTO
USEYOUR
PRESSURE WASHER
If you have any problems operating your pressure washer,
please call the pressure washer heIpline at
I=800=270=1408.
To Start
You r Pressu re Washer
To start your pressure washer for the first time_ follow these
instructions step=by=step.This starting information also applies if
you have let the pressure washer sit idle for at least a day.
. Place the pressure washer in an area close enough to an
outside water source capable of supplying water at a flow
rate greater than 2.2 gallons per minute.
. Check that the high pressure hose is tightly connected to
the spray gun and to the pump. See "Preparing
Pressure
Washer For Use" for illustrations.
o Hake sure unit is in a level position.
° Connect the garden hose to the water inlet on the
pressure washer pump. Turn
ON the water.
CAUTION!
Do Not
run the pump without
the water
supply connected and turned on.You must follow this
caution or the pump will be damage&
° Squeeze trigger on gun until you have a steady stream of
water.This
purges the pump of air and impurities.
. Attach nozzle extension to spray gun (Figure I I).Tighten
by hand.
o Position the nozzle in the low pressure mode (slide
nozzle forward)
and squeeze the trigger on the spray gun
to relieve pressure caused by turning ON the water.
VVater will flow out of the gun in a thin stream. Continue
to hold trigger until there is a steady stream of water
and no air remains in the system. Release the trigger.
° Engage the safety latch to the spray gun triger
(Figure 12).
o Hove the throttle
lever to "Fast"
position, shown here
as a rabbit (Figure 13).
Throttl
Choke Lever
o Hove the choke lever to the "Choke"
position
(Figure 13).
NOTE:
For a warm engine, be sure the choke lever is in
the "P_un" position.
o Place your left foot on the lower frame and grasp the
handle as shown
(Figure
14).Your unit may appear
slightly
different
from that shown
here.
* Pull the starter
grip handle lightly with your right hand
until you feel some resistance,
then pull briskly.
8

Publicidad

Tabla de contenido
loading

Tabla de contenido