Assembly And Adjustments - DeWalt DW802 Manual De Instrucciones

• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction
activities. Wear protective clothing and wash exposed areas
with soap and water. Allowing dust to get into your mouth, eyes,
or lay on the skin may promote absorption of harmful chemicals.
COMPONENTS
A. Paddle Switch
B. Lock-Off Lever
C. Spindle Lock Button
D. Spindle (not shown)
E. Side Handle
(shown on the right)
C
I
A
F. Lock-On Button
G. Unthreaded Backing Flange
H. Threaded Clamp Nut
I. Guard
F
B
G
H

ASSEMBLY AND ADJUSTMENTS

ATTACHING SIDE HANDLE
The side handle can be fitted to either side of the gear case in the
threaded holes, as shown. Before using the tool, check that the
handle is tightened securely. Use a wrench to firmly tighten the
side handle.
Accessories
It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See pages 4-5 for infor-
mation on choosing the correct accessories.
CAUTION: Accessories must be rated for at least the speed
recommended on the tool warning label. Wheels and other acces-
sories running over rated accessory speed may fly apart and
cause injury. Threaded accessories must have a 5/8"-11 hub.
Every unthreaded accessory must have a 7/8" arbor hole. If it
does not, it may have been designed for a circular saw. Use only
the accessories shown on pages 4-5 of this manual. Accessory
ratings must be above listed minimum wheel speed as shown on
tool nameplate.
3
E