Ferroli OMNIA M 3.2 Manual De Instalación Y Del Propietario página 167

OPERATION PARAMETER
FAN SPEED 600R/MIN
IDU TARGET FREQUENCY
FREQUENCY LIMITED TYPE
SUPPLY VOLTAGE
DC GENERATRIX VOLTAGE
DC GENERATRIX CURRENT
ADDRESS
7/9
The power consumption parameter is optional. If some parameter is not be activated in the system, the parameter will
show "--" .
The heat pump capacity is for reference only, not used to judgethe ability of the unit. The accuracy of sensor is ±1 .
The flow rates parameters are calculated according to the pump running parameters,the deviation is different at
different flow rates,the maximum of deviation is 15%.The flow parameters are calculated according to the electrical
parameters of the pump operation.
The operating voltage is different and the deviation is different.
The display value is 0 when the voltage is less than 198V.
#01 OPERATION PARAMETER
TW_O PLATE W-OUTLET TEMP. 35°C
46Hz TW_I PLATE W-INLET TEMP.
5 T2 PLATE F-OUT TEMP.
230V T2B PLATE F-IN TEMP.
420V Th COMP. SUCTION TEMP.
18A Tp COMP. DISCHARGE TEMP.
ADDRESS
NOTE
68
#01 OPERATION PARAMETER
T3 OUTDOOR EXCHARGE TEMP. 5°C
30°C T4 OUTDOOR AIR TEMP.
35°C TF MODULE TEMP.
35°C P1 COMP. PRESSURE
5°C ODU SOFTWARE
75°C HMI SOFTWARE
ADDRESS
8/9
#01
5°C
55°C
2300kPa
01-09-2018V01
01-09-2018V01
9/9