PRE-OPERATION CHECKS
POWER PLUG CHECK
This unit uses a fused power plug.
Always check the power plug before use.
1
Press the RESET button.
2
Insert the power plug into the wall sock-
et.
3
Press the TEST button.
You will hear a CLICK if the circuit breaker is
functioning correctly.
4
Press the RESET button until you hear
another CLICK.
The circuit breaker is activated, power is
supplied, and the unit is now ready for use.
CAUTION:
Do not attempt to use the unit if the above proce-
dure cannot be performed.
Disconnect the power plug and call for service.
LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries.
• Make sure the (+) and (-) polarities are cor-
rectly aligned.
• Lines will appear on the display when batter-
ies are properly installed.
3
Reattach the battery cover.
4
Press the RESET button using a thin
pointed implement.
NOTES:
• The battery life is approximately 1 year in normal
use.
• When replacing the batteries, always change both
and use the same type.
• If you will not be using the unit for a long time, re-
move the batteries from the remote control.
CV-2P10SC_en.indd 16
(AAA(R03))
EN-16
TEST
RESET
Battery cover
11.3.22 11:00:15 AM