USE FOR AIR CONDITIONER
Use when the unit operates with the cool, dehumidification, fan or ventilation mode. During
operation, Plasmacluster ions are released into the room.
• The exhaust hose must be installed in these modes.
• Ensure that the stopcock is securely attached the drainpipe.
• When cool or dehumidification operation is performed at high humidity conditions, water tank inside
the unit may frequently become full. When the water tank is full, the unit stops operating and TIMER,
AIR CON and MAXIMUM lamps will blink. In this case, perform drainage. (see page 26)
COOL MODE
1
Press the MODE button to select COOL mode.
COOL
2
Press the A/C button to start operation.
• The green AIR CON lamp will light.
TO TURN OFF
Press the OFF button.
• The green AIR CON lamp will turn off.
3
Press the TEMP button to set temperature.
• The temperature setting range: 64°F to 86°F.
4
Press the FAN button to set fan speed.
AUTO
DEHUMIDIFICATION MODE
1
Press the MODE button to select DEHUMID-
IFICATION mode.
COOL
2
Press the A/C button to start operation.
• The green AIR CON lamp will light.
• The temperature cannot be set.
• The fan speed is preset to AUTO and cannot be
changed.
TO TURN OFF
Press the OFF button.
• The green AIR CON lamp will turn off.
NOTES:
• Although you can also operate dehumidification mode without the exhaust hose, the unit generates
heat during operation and the room temperature will rise.
• It is also possible to operate in dehumidification mode with hose (not included) attached.
Remove the stopcock and attach the hose to the drainpipe and lead to a floor drain to allow water to
drain from the unit.
CV-2P10SC_en.indd 18
DEHUM
FAN
VENT
QUIET
LOW
HIGH
DEHUM
FAN
VENT
EN-18
2
3
1
4
2
1
11.3.22 11:00:16 AM