Main Unit Operation; Drainage - Sharp CV-2P10SC Manual De Instalación Y Funcionamiento

MAIN UNIT OPERATION

Use this operation when the remote control is not available.
1
Press the POWER button to start opera-
tion.
• The mode will change as you press the button
within 5 seconds.
COOL
(The green AIR CON lamp will light)
ION GENERTOR
(The blue ION GENERATOR lamp will light)
OFF
• In cool mode, the unit will operate at its last
cooling settings. If the unit has been unplugged
since it was last operated, it will resume opera-
tion in the cooling mode, set at 68˚F. The fan
speed set to AUTO.
TO TURN OFF
Press the POWER button during opera-
tion.

DRAINAGE

Drain out water within the unit in the following cases.
• When the unit stops operating and the TIMER, AIR CON and MAXIMUM lamps are
blinking, the water tank is full and need to be drained.
• When the unit is not used for a long time.
1
Unplug the power plug and carefully move
the unit to a drain or outside to avoid wa-
ter spilling out into the room.
2
Remove the stopcock from the drainpipe,
and drain water within the unit.
3
Replace the stopcock securely to the
drainpipe.
CV-2P10SC_en.indd 26
EN-26
1
Stopcock
Drainpipe
11.3.22 11:00:19 AM