Configuration Menu; Configuration Mode - GYS GYSFLASH 30-24 HF Manual De Instrucciones

CONFIGURATION MENU

Access to configuration menu :
To browse in the sub menu press the
«Select» key :
Submenu:
• Languages:
This menu enables to language selection (use the arrows to change the
language).
• Automatic restart:
Automatic restart only works with «Showroom» Mode and «Charge»
Mode. This feature enables the charger to restart automatically and to
restart charging after a cut in power.
This feature is set as default => Display «Configuration | Restart : ON».
• Lock Showroom:
To lock the device in Showroom Mode.
(To avoid misuse)
Shortcut to Lock Showroom:
The «Lock Showroom» feature can be activated without accessing the configuration menu.
• Turn the device OFF (switch on the OFF position)
• Push the MODE key
• Turn the switch ON, while the MODE key is still pressed. Within 3s the display will show «GYS-
FLASH 30-24HF Vx.x»
• Hold the MODE key until the creen displays «lock showroom: Y»
• Charge type:
It is possible to choose the type of charge wanted:
- Automotive charge (automo.) to charge starting batteries
- Traction charge (traction) to charge traction batteries.
• Cables check:
This mode must be used each time the cables are changed. The GYSFLASH can be fitted with cables up to 2x5m
in 16mm².
OK : The calibration was successful.
FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.
Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.
• Advanced Menu (code 1-9-6-4) :
This menu is intended for expert user only.
To access this menu, enter in the code above («Select» key to change the code number and «Start/Stop» key to
confirm the code).
For more details, see page 16.
GYSFLASH 30-24 HF
3 sec - Mode
MODE
languages > restart > lock showroom > cable calibration > ADVANCED
SELECT
MENU > Reset Memory
EN

CONFIGURATION MODE

English
Francais
Deutsch
Nederlands
SETTINGS
Espanol
Francais
Portugues
Italiano
Russian
ON
SETTINGS
restart: ON
OFF
Y (yes)
SETTINGS
lock showroom: N
N (no)
automo.
SETTINGS
charge: automo.
traction
SETTINGS
Cables Testing: Test Cables
Press START
SETTINGS
Advanced Menu: Advanced menu
Press START
SETTINGS
Reset Memory
Reset Memory:
Press START
MODE
15