Rupes BR106AE Instrucciones De Uso página 9

PARTS OF THE TOOL
1 - Identification plate
2 - ON/OFF switch
3 - Speed control
4 - Dust extraction flow control
5 - 29 mm Ø suction port
6 - Auxiliary handle
7 - Heat protection
8 - Dustproof wheel
9 - Velcro faced pad
10 - Motor ventilation slots
11 - Heat protection fixing screws
12 - Spanner
13 - Disc pad fixing screws
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been
damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in
the table and that indicated on the tool identification plate
reproduced and explained on page 11.
ASSEMBLING THE TOOL
- Position the heat protection (7) on the gearbox such that the holes
for mounting the handle are aligned with those on the gearbox;
- screw in the auxiliairy handle (6); the handle can be mounted on the
left or right of the tool body;
- if the tool is to be used without the auxiliary handle, the heat shield
must be fixed in place using the screws provided (11).
MOUNTING THE PAD
1. Place the backing plate (9) with the screw in the centre (13) (fig. 1);
2. slightly turn the backing plate (9) until it is fixed to the screw as
in (fig 2);
3. tighten the screw using the supplied wrench (12) (fig. 3). Do not
tighten the backing plate screw if it is in the wrong position (fig. 4);
4. to remove, follow the same procedure in reverse order.
FITTING ABRASIVE PAPER DISCS
Press the abrasive paper disc into the pad ensuring that the holes in
the paper coincide with extraction holes in the pad.
BEFORE STARTING THE TOOL
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly though with the power supply
disconnected;
- all the parts of the tool have been assembled in the proper manner
and that there are no signs of damage;
- the ventilation slots are not obstructed;
- the tool must be connected to a suitable and efficient aspiration device.
STARTING AND STOPPING
- Starting: push the slide of the switch (2) forward; if the tool is to be
locked in the ON position, apply pressure to the front part of the
slide switch at the same time.
- Stopping: release the slide or, if locked in position, apply pressure to
the back part of the switch and allow it to return to the stop position.
TEST RUN
Start the tool and check that there are no unusual vibration, no
dismatching of the abrasive paper disc.
Otherwise switch-off the tool immediately and eliminate the cause.
9