Setting; Timer - Hitachi CSNET WEB Manual De Instalación Y Funcionamiento

CSNET WEB
Installation & Operation Manual

7.2. Setting

This option shows the parameters that can be selected for each indoor unit
1
2
3
Once you have selected the parameters that must be adjusted,
click "Update" to send the command to the selected units, or
"Cancel" to cancel the operation.
1 Unit Selection
The unit that is selected in the indoor units table are identified
by the "Location" field
Select the group of units whose parameters you want to
adjust with the "Set By" field:
- Single Unit: The selected unit
- Outdoor: All the indoor units that belong to the same
refrigerant circuit.
- Area: All the units that are in the same area
- All: All the units that are contolled by CSNET WEB

7.3. Timer

This option displays the times of operation that can be selected for each indoor unit
Page 16
PMML0163A-rev.0 - 03/2008
2 Parameter adjustment
Click the parameter you wish to select.
Select the temperature with the "" or ""
buttons. The temperature range is:
- From 19ºC to 30ºC for Cooling
- From 17ºC to 30ºC for Heating
Select the fan speed and the position of the louver
by clicking the "Fan speed" and the "Louver" buttons
respectively
3 Parameter Locking
The parameters that have been selected in "RCS Lock" will
remain locked in the position they were in when the option
was activated. This means that they cannot be modified
from the Remote Controller.