Installing Filters, Filter Spacers, & Grease Trays - Thermador PROFESSIONAL VCIN36JP Manual De Instalación

c) Secure to the sides of the frame using six (6) 1''
(25.4 mm) mounting screws provided (Figure 37).
1" (25.4 mm)
mounting screws
X 3 per side
7. Connect to Ductwork
8. Connect electrical wiring
a) Remove the junction box cover (see Figure 7 on
page 10).
b) Remove circular knock-out holes located on back
side of the insert (see Figure 7 on page 10).
c) Connect wiring for blower motor (see blower
instructions beginning on page 10).
d) Ensure all controls are in the OFF position. Plug
electrical cord into grounded outlet.
9. Install hood filters and grease trays
a) Refer to "Installing Grease Trays, Filter Spacers,
and Filters" on page 22.
10. Test the installation.
a) Test the operation of the blower and the lights.
b) Be sure to check for backdraft. With the blower on
high, close the windows and doors to the area to
ensure that fan does not cause back drafting in any
outlet vent for another appliance.
English 22
Figure 37: Side Screws
Installing Grease Trays,
Filter Spacers, and Filters
1. Remove all plastic from hood pieces.
2. Insert in the following order:
a) Grease trays — push down and in. The grease
trays must be in place before installing the filters.
Depending upon the size and model of hood, there
will be from 2 or 3 grease trays per hood.
b) Filter spacers — push down and in at the bottom.
c) Filters — start with center filters, push down, then
push in at the bottom. Depending upon the size
and model of hood, there will be from 2 to 4 filters
per hood.
3. Reverse the above directions to remove the grease
trays, filter spacers, and filters.
Filter
Spacers
NOTE: DO NOT use rangetop burners, elements, or oven
while hood is disassembled.
Filter
Spacers
Filters
Grease Tray
Figure 38: Hood and parts