Grease Trays, Filters And Spacers; Heat Lamp Replacement (Some Models); Halogen Light Replacement - Thermador PROFESSIONAL SERIE Operating And Installation Manual

Installing Grease Trays, Filters and
Spacers
Filter Filter Filter
Spacer Spacer Spacer
Grease Tray Trough Grease Tray Trough Grease Tray Trough
1. Remove all plastic from hood pieces.
2. Insert in the following order:
1) Grease Tray — Push up and in over the rear lip.
Grease Grease
Tray Trough Tray Trough Tray Trough
2) Filters — Slide filter over the front lip. Push filter
rear up, then slide back over rear lip. Depending
upon the size and model of hood, there will be from
1 to 3 filters per hood.
3) Filter Spacer — Insert these the same way as the
filters.
3. Reverse the above directions to remove the grease
tray, filters and filter spacer.
Note: Do not use cooktop while hood is disassembled.
Grease trays must be in place before installing the filters.
Filter Filter Filter
Filters Filters Filters
Spacer Spacer Spacer
Grease Trays Grease Trays Grease Trays
Figure 28: Hood and Parts
Grease Grease Grease
Tray Tray Tray
Figure 29: Grease Tray

Heat Lamp Replacement (some models)

• Turn heat lamp clockwise to install (Figure 30).
• Replace lamp with either a PAR-38 175W heat lamp or
a PAR-40 250W heat lamp.
Refer to the Use and Care Guide for additional information.
Figure 30: Heat Lamp Replacement

Halogen Light Replacement

Bulb
Figure 31: Halogen Light Replacement
1. Using a flat edge from a screwdriver or equivalent tool,
pry loose the lens cover, as shown in Figure 31.
2. Pull damaged bulb straight out from the socket to
remove.
3. Replace with a new 120 V, 40W (maximum) bulb with
G-9 base. Press pins in bulb base straight into socket
until fully seated. Follow package directions and do not
touch new light with bare hands, the oils from your skin
can reduce the longevity of the bulb.
4. Reinstall the light and cover.
Lens
English 17