Benning MM 1 Instrucciones De Servicio página 16

rubber holster  and then clipping the probes into the protective probe
holders on the rear of the holster  (see figure 9).
- A safety test lead can be clipped into the probe holder on the protective
rubber holster  with the test probe protruding, in order to apply the probe
together with the BENNING MM 1 to a measuring point (see figure 10).
- The rear tilt stand on the protective rubber holster  allows the
BENNING MM 1 to be placed standing upright (for easier display reading)
or hung up (see figure 11).
- The protective rubber holster  can also be hung on a nail if so desired.
see Figure 9:
see Figure 10:
see Figure 11:
10/ 2004
Wrapping up the safety test leads
Protective rubber holster with one probe free for single
handed operation
Standing up the BENNING MM 1
BENNING MM 1

14