Festool Charger; Tool Holder, Attachments - Festool TI 15 Manual De Instrucciones Original

6.2 Festool battery packs
 Battery pack is ready for use immediately upon
delivery and can be charged at any time.
Changing the battery pack [2]
The capacity display [1-7] automatically displays
the charge state of the battery pack [1-2] when the
ON/OFF switch is actuated:
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
6.3

Festool charger

Charging the battery pack [3A]
The LED [3-2] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - flashes slowly
Battery pack is charged with
reduced current. Li-ion is
charged to 80 %.
LED green - lit continuously
Charging is complete or is not
restarted as current charge sta-
tus is greater than 80%.
LED red - flashes
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
7 Settings
7.1 Changing direction of rotation [1-3]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Adjust speed/impact rate
CAUTION
Damage to screw and/or workpiece

Adjust the speed/impact rate and impact dura-
tion to the specific application.

Adjust the speed/impact rate at thumbwheel [1-
6]:
Setting 1 = low speed/impact rate
Setting 6 = high speed/impact rate
8

Tool holder, attachments

WARNING
Risk of injury, electric shock

Always disconnect the battery pack before any
type of work on the machine!
Festool offers attachments and tool holders for
various applications.
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2 BF-TI 13 chuck [5]
Is used for clamping drill bits up to 13 mm and
shaft tools.
 Impact mode is automatically switched off when
the chuck is inserted.
Clamp the tool centrally in the chuck.

Pull the sleeve back to clamp the drill bit and
turn this in a clockwise direction until it locks in.
8.3 TI-FX adapter [6]
makes possible the fitting of the following attach-
ments on the power tool (sometimes an accessory).
 Impact mode is automatically switched off when
the adapter is inserted.

Place the three white points in a row when posi-
tioning the adapter. If necessary, the hexagon
socket holder must be turned manually so the
adapter can be fixed.
TI 15
GB
15