General Features; Electrical Features; Working Mode; Other Functioning Features - Aqua HC151 PH-RX Manual De Programación

HC151 PHRX
Digital multifunction solenoid metering pump

PP-PVCinjectionfitting

PP-PVC foot filter with a ball valve

PE delivery tube (2 m)

PVC suctiontube (2 m)

PVC prime dischargetube (2 m)

Wallmountingbracket

Screws for wallmountingbracket

2. GENERAL FEATURES

2.1

ELECTRICAL FEATURES

Power supply:
2.2

WORKING MODE

The pump works in the following modes:

Constant Flow Rate
The pump doses at a constant frequency based on the unit of strokes per/minute set.

ProportionalPH Measure
The pump does the dosage in proportion to the pH signal value by the measure probe (BNC
connector).

ProportionalRX Measure

The pump does the dosage in proportion to the Redox (O.R.P.) signal value by the measure probe
(BNC connector).
2.3

OTHER FUNCTIONING FEATURES


Level Alarm
The pump signals a level alarm when on the input "LEV" this can be programmed as N/O or N/C

Flow Alarm
The pump signals a flow alarm when on the input "FLUSH" there is a closed or open contact
(programmable).

InjectionAlarm
The pump signals an injection alarm when on the input "INJECTION", when the difference
between strokes performed is greater than "returned" strokes (difference programmable).

OFA Alarm
The pump signals OFA alarm, if doses for longer than the interval set

RelaySetting
You can set the alarm relay output "RELAY" in NC (Normally Closed) or NO (Normally Open).
The relay can work as repeat alarm or signaling dosing.

Inhibit
You can set the inhibit (NO or NC) of the pump by input "INHIBIT".

Language
You can set desired language: Italian – English – French – Spanish
ADSP9500092
230VAC 50/60Hz
14/04/2015 Rev. 1.0
Fuse: 1 A RIT – model 5x20
.
ENGLISH
29/123