Operation; Transport; Storage; Maintenance And Care - Kärcher NT 65/2 Eco Manual De Instrucciones

Ocultar thumbs Ver también para NT 65/2 Eco:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Turning on the Appliance
 Plug in the main plug.
 Switch on the appliance at the main
switch.
Filter dedusting
Note: A filter dedusting every 5 to 10 min-
utes will increase the life of the flat folded
filter.
Switch off filter dedusting:
 Push the slide upward.
Switch on filter dedusting:
 Push the slide downward.
Illustration
 Press and hold the switch on the handle
for several seconds while the filter
cleaning is turned on. The flat folded fil-
ter is automatically cleaned through an
air jet (pulsating sound).
Turn off the appliance
 Switch off the appliance at the main
switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside
and outside with a damp cloth.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Exchanging the flat pleated filter
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into
place.
Replace exhaust filter
 Open filter door.
 Replace exhaust filter.
 Close the filter door, it must lock into
place.
Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.

Troubleshooting

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
Suction turbine does not run
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, the power plug
and electrodes of the device.
 Turn on the appliance.
Suction turbine turns off
 Empty the container.
– 3
EN

Storage

7

Publicidad

Tabla de contenido
loading

Tabla de contenido