Preparation; Initial Startup; Operation - Kärcher BV 5/1 Bp Manual De Instrucciones

Accessory hook (fold-out)
21
Floor nozzle
22
Telescopic suction pipe
23
Eco button (energy-saving mode)
24
Charge indicator
25
Suction control
26
Angle piece
27
Suction hose
28
Main switch
29
Colour coding
 Control elements for the cleaning
process are yellow.
 Control elements for maintenance
and servicing are light grey.

Preparation

1. Unpack the device and install the
accessories.
Illustration B

Initial startup

1. Check if the main filter basket is in-
serted in the device.
Operating modes
1 Operation with the fleece filter bag
or paper filter bag (special accesso-
ries)
2 Operation without the filter bag
Adjust the hip belt and shoulder
straps
1. Put the device on its back.
2. Engage the lock and adjust the hip
belt.
Illustration C
3. Adjust the device to the body by pull-
ing on the centre straps. Do not put
on too tight, the main load should be
on the hip belt.
Illustration D
4. Adjust the position of the device on
the back by pulling on the final
straps.
Illustration E
8
Inserting the battery pack
1. Slide the battery pack into the bat-
tery holder and lock it in place.
Charging the battery pack
Note
Please read the operating instructions
of the charger manufacturer, especially
the chapters on safety instructions!
Note
Please read the operating instructions
of the battery pack manufacturer, es-
pecially the chapters on safety instruc-
tions!
Note
The battery pack is partially charged on
delivery. Charge before use and when
necessary.
Note
The battery pack can only be charged
when it is removed.
1. Press the unlocking button and re-
move the battery pack.
2. Charge the battery pack according
to the operating instructions of the
charger manufacturer and the bat-
tery pack manufacturer.
ATTENTION
Danger due to technical defect
Risk of damage to the device
Immediately switch off the engine as
the suction performance decreases.
Switch on the device
1. Switch on the device at the main
switch.
English

Operation