Thrustmaster Ferrari Wireless GT Cockpit 430 scuderia Edition Manual Del Usuario página 18

EXAMPLES OF POSSIBLE USES:
- On PS3, programme L2/R2 or L3/R3 onto the Up and Down gearshift paddles (L1/R1 by default).
- On PS3, programme the Cross/Square buttons onto the pedals (L2/R2 by default).
- Switch different buttons for better access.
Note: The
EEPROM MEMORY
Your wheel has an internal chip that stores all your "MANUAL PRESET" programmes in memory (even
when the wheel is off or disconnected for a long period of time).
You can save a different "MANUAL PRESET" on each support used (PC and PS3).
DELETING A "MANUAL PRESET"
Steps
1
Activate your "MANUAL PRESET"
Press and hold the MAPPING
2
Your "MANUAL PRESET" is now blank (and becomes identical to the "AUTOMATIC PRESET").
RETURN TO "FACTORY SETTINGS"
The aim here is to remove all of your programming or settings in one go.
Steps
Simultaneously press the following buttons
1
MAPPING
All your "MANUAL PRESETS" (PC + PS3) or settings are now blank.
Note: The result of this action is to fully restart your wheel. On a PC, you should
therefore carry out this operation only when no game is currently playing.
TROUBLESHOOTING
The wheel is not perfectly centred in the games:
- Switch off the wheel (by setting the switch to OFF). Physically centre the wheel. Next, switch the wheel
back on (by setting the switch to ON).
- If the problem persists, you can manually centre the wheel. To do this, position the wheel in perfect
alignment with the centre, and then simultaneously press "SELECT + START + ENGINE START" (this
operation must be carried out each time the wheel is switched on).
- On the PC, if the wheel or pedals are not properly calibrated, download the "Thrustmaster Calibration
Tool v 1.03" manual calibration software available at the following address: http://ts.thrustmaster.com.
button cannot be programmed or moved.
Action
button for 2 seconds.
Action
+ SELECT + START
17/20
LED status
On
Flashes for 2 seconds
LED status
Flashes for 5 seconds