Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Serial Remote HMI
4 ACCESSORY INSTALLATION
The accessory is easily installed or replaced. For the
proper installation of the accessory, follow steps below:
Step 1: the CFW501-HMIR can be connected to any
CFW501 plug-in module. With the inverter de-energized,
remove the front cover of the Inverter
page
14).
Step 2: connect the wires of the CFW500-CCHMIRxxM
cable to the RS485 connection on plug-in module
according to the
on page 14
shows an example with the CFW500-IOS
plug-in module. If you are using a different plug-in module,
refer to its installation, configuration and operation guide
to identify the terminals for the RS485 Serial Connection.
Step 3: close the inverter front cover.
Step 4: power up the inver ter and check if the
CFW501-HMIR as show the following mensage on the
display:
Step 5: configure the parameter P0312 to HMIR
option. Thus, the Serial Remote HMI will show the
same display data as the inverter local HMI. Otherwise,
repeat steps 1-5, checking the CFW500-CCHMIRxxM
cable connections.
5 CONFIGURATIONS
It is mounted externally to the inverters on the panel
„
door
(Figure A2 on page
maximum cable length of 10 m. However, for cables
longer than 10 m, it is necessary an external power
supply of 24 Vdc to power up the Serial Remote HMI.
Protection rate: IP54 / Nema 12.
The CFW501-HMIR works with the CFW500-
„
CCHMIRxxM cable only. The available lengths are
presented in
connection of this cable, check
6 | CFW501
Table 2 on page
15) or control desk with a
Table 1 on page
(Figure A1 on
7. The
Figure A1
7. For the proper
Table 2 on page
7.
Publicidad
Tabla de contenido
