General Information; Package Content; Mechanical Installation; Electrical Installation - WEG NT538 Guía De Instalación, Configuración Y Operación

Kit Tecsystem for MVW-01
Sumarry - English
I. Safety Notices...................................................................................................01
II. General Information.........................................................................................01
III. Package Content..............................................................................................01

1. Mechanical Installation......................................................................................01

2. Electrical Installation.........................................................................................01

3. Configuration and Operation Guide...................................................................02
Installation, Configuration and Operation Guide
I. SAFETY NOTICES
ATENTTION!
- Always disconnect the power supply before making any connection.
II. GENERAL INFORMATION
This Guide defines the installation, configuration and operation procedures of the Kit
Tecsystem for the MVW-01.
III. PACKAGE CONTENT
Quantity
Entrada de señales de encoder
1
1
1
1
1. MECHANICAL INSTALLATION
The Kit Tecsystem should be installed inside the panel door of the MVW-01 control, or
inside the control panel.
The Kit should be installed in such way to ensure easy access to the terminals.
2. ELECTRICAL INSTALLATION
For the electrical installation of the Kit Tecsystem, proceed as follows:
Step 1 Read carefully the instructions supplied with the Tecsystem NT538;
Step 2 Ensure that the inverter is always disconnected from the power supply before
making any connection;
01
Step 3
board
Kit Tecsystem for MVW-01
Kit Tecsystem for MVW-01
Description
TECSYSTEM NT538
Power supply cable
Power supply cable
Protection cable
Connect the communication cable between the XC8 connector of the
MVC1 and the terminals 60(GND), 61(-) and 62(+) of the NT538;
Code
0304.1214
0307.8261