ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).
– To avoid short circuits the battery pack should be
stored in the packaging supplied.
11
Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble country-specific regulations.
EU only: European Directive 2002/96/
EC stipulates that used electric power tools must
be collected separately and disposed of at an envi-
ronmentally responsible recycling centre.
Return used or faulty battery packs to your local
specialist retailer, Festool after-sales service or a
designated public waste management facility. The
battery packs will then be recycled. (Observe the
regulations applicable in your country). The batter-
ies must be discharged on return.
EU only: European Directive 91/157/EEC stipulates
that faulty or used battery packs/batteries must be
recycled.
Information on REACh: www.festool.com/reach
12
Transport
The equivalent amount of lithium in the LiIon bat-
tery pack is less than the applicable limit value and
certified as per UN manual ST/SG/ AC.10/11/rev. 3
part III, subsection 38.3. The LiIon battery pack is
therefore not subject to national and international
dangerous goods regulations, neither as an individ-
ual component nor as a fitted machine component.
However, dangerous goods regulations may apply
when several battery packs are transported, in
which case you may have to fulfil special conditions.
Refer to ADR special regulation 230 for more infor-
mation relevant for the EU.
13
EU Declaration of Conformity
Cordless drill
CXS
Year of CE mark: 2010
We declare under sole responsibility that this prod-
uct complies with the following directives and stan-
dards:
2006/42/EC,
2004/108/EC,
03.01.2013), EN 60745-1, EN 60745-2-1, EN 60745-
2-2, EN 55014-1, EN 55014-2.
Charger
MXC
Year of CE mark: 2010
We declare under sole responsibility that this prod-
uct complies with the following directives and stan-
dards:
2004/108/EC, 2006/95/EC, 2011/65/EU, EN 60335-
1, EN 60335-2-29, EN 61000-3-2, EN 61000-3-3, EN
61204-3.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
07.02.1013
CXS
GB
Serial no.
495635
2011/65/EU
(from
Serial no.
495883
13