Operation Panel - Oki IP-6620 Guía De Consulta Rápida

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 154

Operation panel

The buttons, LEDs and LCD are placed on the printer's operation panel as shown below. In addition, the operation
panel is also equipped with a buzzer to draw attention in case an error occurs or an invalid button is pressed.
The printer enters waiting mode if it is not used for a given length of time.
• LED
ON, blinking and OFF indicate the
status of the printer.
Refer to the table below.
• LCD
It shows the status of the printer and
displays the menu window (2 rows, 20
characters).
Waiting mode
(During waiting mode)
LCD: Display and backlight turned off
Online LED: Flashes slowly
Other LEDs: Off
(Exiting waiting mode)
The printer exits waiting mode when
- any button is pressed,
- the printer receives print data.
• Buzzer
Sounds when an error occurs or an
invalid button is pressed, and warns of
daily maintenance and when the print
heads are uncapped.
Indicates whether an error has occurred.
ON: An error has occurred.
Error LED
Blink: Warning state.
(Orange)
OFF: Normal (no error)
Indicates the status of the media heater.
- ON: The set temperature has been reached
- Blink: Currently heating
Media heater LED
- OFF: Media heater is off
(Green)
Indicates whether ink is remaining.
ON: Ink of all colors is present.
Ink LED (Green)
Blink: Ink near-end (The level of any color is low.)
OFF: No ink.
Indicates the online, offline, data reception, and
pause status.
ONLINE LED
- ON: Online
(Green)
- Blink (slowly): In pause
- Blink (fast): Data reception
- OFF: Offline
SET
ORIGIN
CANCEL
HEATER
ADJUST
NOZZLE PRINT
LED
• Up, Down, Left, Right buttons
Used to select menu options, switch
between menus (selection, increasing/
decreasing values), etc.
• OK button
Used to confirm the menu and
parameters.
ONLINE
MENU
• Buttons
Use these buttons to operate the menu
MAINTENANCE
of the printer.
Refer to the table below.
PH.RECOVERY
• Power switch
Used to turn on or off the power of the
printer.
POWER
Used to manually enter and exit waiting
mode.
Buttons
Cancels entered parameters or returns back to the
CANCEL
upper menu.
Switches between online and offline states, and
ONLINE
puts the printer in pause or resumes printing.
Enters heater control menu.
HEATER
Used to display information about the printer and
MENU
change printer settings.
Used to enter the adjustment menu.
ADJUST
MAINTENANCE
Used to enter the maintenance menu.
Used to perform a nozzle print.
NOZZLE PRINT
Used to enter the cleaning menu.
PH.RECOVERY
29

Publicidad

Tabla de contenido
loading

Tabla de contenido