Storing The Mattress - Hill-Rom Primo P02033 Manual De Usuario

PROPRIETARY AND CONFIDENTIAL DRAFT: octobre 11, 2012
2. Disconnect the power cord from the wall outlet.
3. Remove the cable clamps that attach the power cord to the bed.
4. Undo the two straps securing the mattress to the bed (at the head and foot
ends).
5. Place the control unit on the mattress to prevent it from being damaged.
6. Transfer the mattress on the other bed.
7. To install the Primo
installation procedure (page 16).

Storing the mattress

Make sure that the bed frame brakes are applied to prevent any accidental
movements.
1. Switch off the device by pressing
The indicator light goes out.
2. Activate the CPR valve to help expel air from the mattress.
3. Disconnect the power cord from the wall outlet.
Never pull on the power cord or you may damage it. A damaged power
cord is an electric shock hazard.
4. Remove the cable clamps that attach the power cord to the
bed.
5. Disconnect the air hose and electric cable connector of the CPR valve.
6. Undo the two straps securing the mattress to the bed (at the head and foot
ends).
7. Starting at the head end of the bed, roll
up the mattress slowly to allow any
remaining air to be expelled and place
the rubber bands on each end of the
rolled mattress.
8. Close the CPR valve to prepare the
mattress for the next installation.
9. Store the mattress in its transport bag
(see "Transport bag" page 36).
Page 24
on the other bed, refer to steps 4 to 16 of the
™
.
170924(2) - EN - Primo User Manual
™