Menu Functions; Automatic Power On/Off - SKF THGD 100 Instrucciones De Uso

6. Menu functions

MENU
ZERO
RESET
OK

6.1 Automatic power on/off

Press MENU/ZERO for 2 seconds. MEnu will be displayed.
Press MENU/ZERO briely and depending on the set up, two different displays
are possible:
If PO On is displayed, then the device is currently set in PO off
(no automatic power off) mode.
To change to automatic power on mode press RESET/OK.
If PO OFF is displayed, then the device is currently set in PO on
(automatic power off) mode.
To change to automatic power off mode press RESET/OK.
Wait a few seconds and the display reverts to the actual pressure reading
display or press MENU/ZERO to continue to 6.2.
The settings Auto Power Off or Continuous operation remain stored and are
active when the THGD 100 is turned off and on again.
SKF THGD 100
MENU/ZERO is used to access the menu functions.
The following settings can be made in the MENU function:
• Auto Power Off – on (30 minutes)
or off (continuous operation)
• Unit selection (MPa or PSI)
• Serial number display
RESET/OK
11