Cleaning & Care; Tumble Dryer; Error Codes - Haier HD70-A82 Manual De Instrucciones

CLEANING & CARE

TUMBLE DRYER

Wipe the outside of the tumble dryer and the control panel with a damp cloth. Do
not use any organic solvent or corrosive agent to avoid damage to the device.
DRUM
After some operation time, fabric care agents or calcium contained in the water
some detergent to remove it. Do not use any organic solvent or corrosive agent
to avoid damage to the device.
EVAPORATOR
a vacuum cleaner. Make sure not to damage the evaporator while cleaning it.

ERROR CODES

CODE CAUSE
F2 Drain pump error.
F31, F32, The condenser thermal
F33 sensor is open-circuited or
short-circuited.
F4 Temperature of the laundry
in the drum does not
change.
E6
The filters is clogged.
E7 Under voltage or over
voltage fault.
Over load warning.
E8
Temperature is too low.
Lo
SOLUTION
Contact the customer service.
Contact the customer service.
Contact the customer service.
Clean both filters.
Check the voltage of power suply.
Or contact the customer service.
Reduce the load,Repower the dryer.
Or contact the customer service.
Use the dryer when air temperature
is higher than 2 ℃.
English | 19