tau K691M Guía Para La Instalación página 16

of the system control unit. Activation of self-learning mode on the control unit and memorisation of the new
radio control:
1 On the operative (old) radio control, press and hold the key for channel 1, and press the channel 2
key three times.
2 Release the keys. The radio control led starts flashing to indicate that the self-learning mode is enabled.
3 Still on the operative (old) radio control, press the key currently used to activate the automation for
at least 3 seconds.
4 At this point the control unit confirms changeover to programming mode by activating the flashing
light (except for external receivers in the RXDC series).
5 Press the radio control key to be memorised again. If programming is successful, the control unit
flashing light turns off.
DELETING RADIO CONTROLS
1_ press and hold the RADIO key for approx. 3 seconds to delete all associated radio controls;
2_ led DL3 starts flashing slowly to indicate that deletion mode is enabled;
3_ release the RADIO key and press again for 3 seconds;
4_ led DL3 turns off for approx. 3 seconds, and then remains lit to confirm deletion;
5_ to exit deletion mode, briefly press the RADIO key.
MANUFACTURER'S DECLARATION OF INCORPORATION
(in accordance with European Directive 2006/42/EC App. II.B)
Manufacturer:
Address:
Declares under its sole responsibility, that the product:
designed for automatic movement of:
for use in a: Residential / Communities
Model: K691M
Serial number: see silver label
Has been produced for incorporation on an access point (swing gate) of for assembly with other devices used to
move such an access point, to constitute a machine in accordance with the Machinery Directive 2006/42/CE.
Also declares that this product complies with the essential safety requirements of the following CEE directives:
- 2006/95/CE Low Voltage Directive
and, where required, with the Directive:- 1999/5/CE Radio equipment and telecommunications terminal equipment
Also declares that it is not permitted to start up the machine until the machine in which it is incorporated or of
which it will be a component has been identified with the relative declaration of conformity with the provisions of
Directive 2006/42/CE.
The manufacturer undertakes to provide, on sufficiently motivated request by national authorities, all information
pertinent to the quasi-machinery.
Sandrigo, 26/11/2014
Name and address of person authorised to draw up all pertinent technical documentation:
Loris Virgilio Danieli - via E. Fermi, 43 - 36066 Sandrigo (Vi) Italy
TAU S.r.l.
Via E. Fermi, 43 - 36066 Sandrigo (Vi) ITALY
Electronic control unit
Garage door
complete with: Radioreceiver and battery charger board
Type:K691M
Commercial name: Control panel for one 24V motors with encoder
- 2004/108/CE Electromagnetic Compatibility Directive
Legal Representative
_________________________________________
16
Loris Virgilio Danieli