Ryobi RBL30BPT Manual De Utilización página 19

EN
FR DE ES IT PT
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
Engine starts but will only run
at high speed at half choke.
Engine does not reach full
speed and emits excessive
smoke.
Engine starts, runs, and but
will not idle
RBL30BPT V1.indd 17 RBL30BPT V1.indd 17
NL SV DA NO FI EL HU CS RU
English
TROUBLESHOOTING
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Engine is flooded
4. Starter rope pulls harder now
than when new.
Carburetor requires adjustment.
Carburetor requires adjustment.
1. Oil / fuel mixture is incorrect.
2. Air filter is dirty.
3. Spark arrestor screen is dirty.
Idle speed screw on carburetor
needs adjustment.
17
RO PL SL HR TR ET
SOLUTION
1. Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and watch
for spark at spark plug tip. If there is no spark,
repeat test with a new spark plug.
2. Push primer bulb until fuel is visible in the
bulb. If fuel is not apparent, the primary
fuel delivery system is blocked. Contact a
servicing dealer. If primer bulb fills, engine
may be flooded (see next item).
3. Remove spark plug, turn blower so spark plug
hole is aimed at the ground. Rotate the choke
dial to "RUN" position and pull starter cord 10
to 15 times. This will clear excess fuel from
en gine. Clean and reinstall spark plug. Pull
starter three times with choke dial at "RUN".
If en gine does not start, rotate choke dial to
"FULL CHOKE" position and repeat normal
starting pro ce dure. If engine still fails to start,
repeat pro ce dure with a new spark plug.
4. Contact a servicing dealer.
Contact a servicing dealer for carburetor
adjustment.
Contact a servicing dealer for carburetor
adjustment.
1. Use fresh fuel and the correct 2-stroke oil
mix.
2. Clean air filter.
3. Contact a servicing dealer.
Turn idle speed screw clockwise to increase
idle speed.
LT LV SK BG
5/14/09 8:41:40 AM 5/14/09 8:41:40 AM