Repair Parts - Flotec E75STVT Manual Del Usuario

Operation / Service
For automatic operation, plug or wire pump into an
automatic float switch or pump controller. Pump will run
continuously when plugged directly into an electrical outlet.
Connect or wire pump to its own individual branch circuit
with no other outlets or equipment in the circuit. Size fuses
or circuit breakers according to Specifications chart.
Risk of electric shock and fire. Can shock,
burn or kill. Be sure that power supply information
(Voltage/Hertz/Phase) on pump motor nameplate matches
incoming power supply exactly. Install pump according to
all electrical codes that apply.
Operation
NOTICE Do not allow pump to run in a dry sump. It will
void the warranty and may damage the pump.
An automatic overload protector in the motor will
protect motor from burning out due to overheating/
overloading. When motor cools down, overload
protector will automatically reset and start motor.
If overload trips frequently, check for cause. It could be
a stuck impeller, wrong/low voltage, or electrical failure
in motor. If an electrical failure in the motor is suspected,
have it serviced by a competent repairman.
Pump is permanently lubricated. No oiling or greasing
is required.
WARNING
Hazardous voltage.
Can shock, burn, or cause
death.
Ground pump before
connecting to power
supply. Disconnect power
before working on pump,
motor or tank.
For parts or assistance, call Flotec Customer Service at
Service
kill. Before removing pump from basin for service, always
disconnect electrical power to pump and control switch.
kill. Do not lift pump by power cord. See "Cord Lift
Warning" below.
Submerge pump in a disinfectant solution (chlorox or
chlorine) for at least one hour before servicing pump.
The pump motor contains a special lubricating oil which
should be kept clean and free of water at all times.
Check operation by filling sump with water and
observing pump operation through one complete cycle.
and/or property damage. Failure to make this operational
check may lead to flooding and premature failure.
NOTICE This unit is not designed for applications
involving salt water or brine! Use with salt water or brine
will void warranty.

Repair Parts

Power Cord: 10', 115 V .................................21628B046
Tethered Float Switch ............................. PW117-267-TSE
Impeller .............................................................PS5-273P
or kill. Disconnect pump from electrical power before
replacing cord or switch. Do not remove impeller
housing (volute). There are no consumer serviceable
parts inside the pump.
Cord Lift Warning
Risk of electric shock. Can shock, burn or
Risk of electric shock. Can shock, burn or
Risk of flooding. Can cause personal injury
Risk of electric shock. Can shock, burn
1. Attempting to lift or support pump
by power cord can damage cord and
cord connections.
2. Cord may pull apart, exposing bare
wires with possibility of fire or electri-
cal shock.
3. Lifting or supporting pump by power
cord will void warranty.
4. Use lifting ring or handle on top of
pump for all lifting/lowering of pump.
Disconnect power to pump before
doing any work on pump or attempt-
ing to remove pump from sump.
800-365-6832
4