Tabla de contenido
Publicidad
• cutting, high, wet vegetation;
• operator behaviour that should be avoided:
• switching the machine on and off
frequently whilst working;
• using a cutting means or cutting
technique that is unsuitable for the
work to be performed (par. 6.4);
• cutting speed unsuitable for the
condition of the grass to be cut.
To optimise battery power reserve
it is always recommended to:
• cut the grass when dry;
• set a cutting speed suitable for
the condition of the grass;
• use the most appropriate cutting means and
technique for the work to be performed.
NOTE
The battery charge level can be monitored
by checking the specific indicator
located on the hand grip (Fig. 11.C).
If the need arises to use the machine for
sessions which exceed the capability of
a standard battery, it is possible to:
• choose the second battery (if any) from
the battery backpack (Fig. 10.B);
• purchase additional standard batteries
to immediately replace the discharged
battery, without compromising
the continuity of operations;
• purchase a battery with an extended
power reserve compared to the
standard version (para. 15.1).
7.2.2 Battery removal and recharging
1. Press the locking button located
on the battery (Fig. 21.A) and
remove the battery (Fig. 21.B);
2. Fit the battery (Fig. 22.A) in the battery
charger compartment (Fig. 22.B);
3. Connect the battery charger (Fig. 22.B)
to a power socket with the voltage
indicated on the rating plate;
4. Fully charge the battery according to the
instructions in the battery charger manual.
NOTE
The battery is equipped with a protection device
that inhibits recharging if the environmental
temperature is not between 0 and +45°C.
NOTE
The battery can be charged at any time,
even partially, with no risk of damaging it.
7.2.3 Refitting the battery on the machine
When recharging is completed:
1. Remove the battery (Fig. 23.A) from the
housing in the battery charger (do not keep
charging when recharging is completed);
2. Disconnect the battery charger (Fig.
23.B) from the electrical mains;
3. Insert the battery (Fig. 9) in one of the
compartments of the battery backpack
and push it completely, until hearing the
click that signals its locking in position,
ensuring thus the electrical contact.
7.3 CLEANING THE MACHINE
AND THE ENGINE
• Always clean the machine after use with a
damp cloth dipped in neutral detergent.
• Remove all traces of humidity using
a soft damp cloth. Humidity can
generate risks of electric shocks.
• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
• To reduce fire hazards, keep the machine
and, in particular, the motor free of
grass, leaves, or excessive grease.
• To avoid overheating and damage to the
engine, always keep the cooling air vents
(Fig. 1.A) clean and free of debris.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
7.4
NUTS AND BOLTS
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the
handles are fixed firmly.
8. OCCASIONAL MAINTENANCE
8.1 CUTTING MEANS MAINTENANCE
Cutting means displaying the code
indicated on the Technical Data table
should only be used on this machine.
EN - 16
Publicidad
Tabla de contenido
