Stiga BC 900 D Li 48 Manual De Instrucciones página 39

PROBLEM
5. Grass accumulates
around the shaft
housing and line
holder head.
6. The line is not released
when the line holder
head hits the ground.
7. The cutting means
comes into contact
with a foreign body.
8. Excessive noise and/or
vibration is experienced
whilst working.
9. The machine emits
smoke during operation.
10. Battery power
reserve is low.
11. The battery charger is
not charging the battery.
If problems persist after having performed the operations described above, contact your dealer.
PROBABLE CAUSE
Too high grass is being cut
close to the ground.
The line is stuck.
Not enough line on the
reel or reel empty.
The line is worn and too short.
The line is tangled on the reel
or broken inside the reel.
-
Loose or damaged parts.
Machine damaged.
Severe working conditions
requiring greater
current absorption.
Battery is insufficient for
operating requirements.
Decrease in battery capacity.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
SOLUTION
Cut tall grass with a sweeping
motion to avoid build up.
Lubricate with silicone spray.
Replace the line (chapter 8.1.3.).
Pull the line whilst pressing
the release button.
Remove the line from the reel and
rewind it (chapter 8.1.3).
Stop the machine, disconnect it
from the battery backpack and:
•
inspect for damage;
•
check for and tighten any loose parts;
•
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Stop the machine, disconnect it
from the battery backpack and:
•
inspect for damage;
•
check for and tighten any loose parts;
•
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Do not use the machine. Immediately
stop the machine, disconnect it
from the battery backpack and
contact an Authorised Service Centre.
Optimise operations (par. 7.2.1).
Use a second battery or an
extended battery (par. 15.1).
Purchase a new battery.
Check it is correctly inserted (par. 7.2.2).
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.