Ryobi PBT01B Manual Del Operador página 13

Sierra ingleteadora deslizante de 184 mm (7-1/4 pulg.), 18v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MOUNTING HOLES
See Figure 7.
WARNING:
Before starting any cutting operation, clamp or bolt
your miter saw to a workbench or an approved miter
saw stand. If a miter saw stand is used, read operator's
manual and follow the instructions for the miter saw
stand. Never operate your miter saw on the floor or in a
crouched position. Failure to heed this warning can result
in serious personal injury.
The compound miter saw should be mounted to a firm sup-
porting surface such as a workbench, mounting board, or
miter saw stand. The saw base has four mounting holes. If
using bolts, they should be of sufficient length to accom-
modate the saw base, lock washers, hex nuts, and the thick-
ness of the workbench or other mounting surface. Tighten
all bolts or screws securely.
The hole pattern for mounting to a workbench is shown in
figure 7. Carefully check the workbench after mounting to
make sure that no movement can occur during use. If any
tipping, sliding, or walking is noted, secure the workbench
to the floor before operating.
USING THE DEPTH STOP
See Figure 8.
When used, the depth stop limits the downward travel of
the blade when cutting dadoes and other non-through cuts.
To use the depth stop:
 Remove the battery.
 If the saw is in storage or transport position, unlock the
saw arm.
 Rotate the depth stop away from the motor housing.
 With the end of the depth control knob touching the depth
stop, adjust the depth control knob by turning the knob
until the desired depth of cut is attained.
 A wooden spacer of at least 2-1/2 inches must be placed
between the workpiece and the fence for a consistent
depth of cut in the workpiece. Use the work clamp to
clamp the spacer and another suitable clamp to clamp
the workpiece. Make the slide cut at the desired depth.
See Figures 34 - 35.
 Rotate the depth stop back towards the motor housing
for normal through cuts.
NOTE: The depth stop must be moved toward the motor
housing before locking/unlocking the saw arm.
ASSEMBLY
CONTROL KNOB
DEPTH STOP
13 − English
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
TRACE HOLES
AT THESE LOCATIONS
FOR HOLE PATTERN
DEPTH
SAW BASE
MOUNTING
SURFACE
Fig. 7
Fig. 8

Publicidad

Tabla de contenido
loading

Tabla de contenido