Ryobi PBT01B Manual Del Operador página 19

 Loosen the fence screw and slide the partial sliding miter
fence toward the blade to access the socket head screws
securing the left miter fence to the table.
 Using the blade wrench provided, loosen the socket head
screws that secure the miter fence to the miter table.
 Rotate the miter fence left or right until the saw blade is
parallel with the square.
 Retighten the screws securely and recheck the blade-to-
fence alignment.
 Return the partial sliding miter fence to the home position
and retighten the fence screw to secure.
Your saw has several scale indicators. After squaring adjust-
ments have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figures 21 - 22.
SQUARING THE BLADE TO THE MITER TABLE
See Figures 23 - 25.
 Remove the battery.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
 Rotate the miter table until the scale indicator on the
control arm is positioned at 0°.
 Release the detent release lever, engaging the positive
stop notch, then tighten the miter lock knob to secure
the miter table.
 Loosen the bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Place a combination square against the miter table and
the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 23.
 If the top or bottom of the saw blade angles away from
the square as shown in figures 24 and 25, adjustments
are needed.
 Loosen bevel lock knob.
 Adjust positive stop adjustment screw to bring saw blade
into alignment with the square. See Positive Stop Adjust-
ment in the Adjustment section.
 Tighten bevel lock knob. Recheck blade-to-table
alignment.
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0°
and 45° angles.
Your saw has several scale indicators. After squaring adjust-
ments have been made, it may be necessary to loosen the
indicator screws and reset them to zero. See Figures 21 - 22.
ASSEMBLY
MITER
FENCE
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
19 − English
MITER
TABLE
COMBINATION
MITER
SQUARE
LOCK HANDLE
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
MITER
TABLE
COMBINATION
SQUARE
ADJUSTMENTS ARE REQUIRED
MITER
TABLE
COMBINATION
SQUARE
ADJUSTMENTS ARE REQUIRED
BLADE
Fig. 23
BLADE
Fig. 24
BLADE
Fig. 25