Clamping Wide Workpieces - Ryobi PBT01B Manual Del Operador

If the warped material is positioned the wrong way as shown
in figure 42, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 43.
When cutting wide workpieces, such as nominal 2 in. x 6 in.,
boards should be clamped with a work clamp as shown in
figure 43.
OPERATION
30 − English
WRONG
Fig. 42
WIDE
BOARD
Fig. 43