Ryobi PBT01B Manual Del Operador página 17

WARNING:
Make sure the spindle lock button is not engaged be-
fore reconnecting saw into power source. Never engage
spindle lock button when blade is rotating.
REMOVING/REPLACING THE THROAT PLATE
See Figure 16.
WARNING:
The throat plate must be below the miter table. If the
throat plate is too high or too low, the workpiece can
catch on the uneven edges resulting in binding which
could result in serious personal injury.
Never operate the saw without a throat plate installed.
To remove/replace:
 Remove the battery.
 Remove the screws securing the throat plate.
 Lift the throat plate from the saw.
 To reinstall the throat plate, align the holes in the throat
plate with the holes in the saw base.
 Retighten the screws, being careful not to overtighten
which can cause the throat plate to bow or bend.
ADJUSTING SUPPORT FOOT
See Figure 16.
Turn the support foot clockwise or counterclockwise depend-
ing on the amount of support needed for making sliding cuts.
NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so
that we can clearly show points being made in the illustra-
tions. Never operate the saw without all guards securely
in place and in good operating condition.
SQUARING THE BLADE TO THE FENCE
See Figures 17 - 22.
 Remove the battery.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
 Rotate the miter table until the scale indicator is posi-
tioned at 0°.
 Release the detent release lever, engaging the positive
stop notch, then tighten the miter lock knob to secure
the miter table.
 Tighten the miter lock knob to secure the miter table.
 Loosen bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
ASSEMBLY
MITER
FENCE
17 − English
THROAT
PLATE
SUPPORT
FOOT
SQUARE
MITER
TABLE
MITER
LOCK HANDLE
VIEW OF BLADE SQUARE WITH FENCE
Fig. 16
BLADE
Fig. 17