Ryobi PBT01B Manual Del Operador página 28

NESTING CROWN MOLDING AGAINST THE
MITER FENCE
See Figure 37 - 39.
NOTE: This method of cut is for crown molding up to 3-3/8 in.
tall, when using an auxiliary fence (as described on page 24).
Do not attempt to cut molding that is larger than 3-3/8 in. tall.
NOTE: It may be necessary to adjust the partial sliding miter
fence to ensure proper clearance prior to making the cut.
 Assemble and attach auxiliary fence as shown in
figure 34.
 Loosen the slide lock knob.
 Slide the saw forwards or backwards to align the arrow on
the crown indicator with the arrow on the pivot assembly,
then tighten the slide lock knob securely.
 Set the bevel angle at 0° and the miter angle at 45° to
either the left or the right. (For making 90° corners.)
 Nest and secure the crown molding against auxiliary fence
using a spring clamp and hold crown molding securely.
 Before turning on the saw, perform a dry run of the cutting
operation to make sure that no problems will occur when
the cut is made.
 Grasp the saw handle firmly. Depress the trigger lockout
lever and squeeze the switch trigger. Allow several sec-
onds for the blade to reach maximum speed.
 Slowly lower the blade into and through the crown
molding.
OPERATION
AUXILIARY
FENCE
CROWN
INDICATOR
SPRING
PIVOT
CLAMP
ASSEMBLY
INDICATOR
Fig. 37
28 − English
SPRING
CLAMP
CROWN
MOLDING
BOTTOM EDGE
AGAINST FENCE
Fig. 38
Fig. 39