Makita DFT041R Manual De Instrucciones página 6

LED indicator / Beeper
For LED#A (Fig. 5)
Led indicator / Beeper on the tool shows the following functions.
Status of
the LED indicator/beeper
LED indicator Beeper
Lights up in
Green A series of
Red very short
Blue beeps
White in order.
Blinks in A series of
purple slowly. long beep
Lights up in
A long beep
purple.
Lights up in
A series of
red and green
short beeps
alternatively.
Blinks in red A series of
quickly. short beeps
Green (blue
when batch is
completed in
tool stand-
alone mode)
Lights up in
A long beep
red.
Lights up in
A long beep
yellow.
007930
6
Function
Check LED#A,
light and beeper
(when pulling
Make sure that green, red, blue, white
switch trigger for
LED lights up and beeper beeps
the first time after
properly.
installing a battery
cartridge into the
tool)
Warning for This indicates the appropriate time to
battery cartridge replace the battery cartridge when the
capacity battery power becomes low.
Checking the This function works when the battery
remaining battery power is almost used up. At this time,
capacity, Autostop tool stops immediately.
This function works when an abnormal
Anti-reset of
drop of the battery voltage occurs for
controller
some reason, and the tool stops.
Failure of motor This function works when motor fails.
This function works when the
Overheat temperature of the controller or motor
goes up very highly, and the tool stops.
This function works when the tool has
Auto-stop reached within the fastening torque
fastening range preset on PC and normal
tightening has been completed. (Note)
Result of torque This function works when the tool has
judgment: NOK reached above the fastening torque
(High) range preset on PC. (Note)
Result of torque This function works when the tool has
judgment: NOK reached below the fastening torque
(Low) range preset on PC. (Note)
Status Action to be taken
__
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
Replace the battery
with fully charged
one.
Take it to a Makita
Authorized Service
centers.
Remove the battery
cartridge immediately
and cool the tool
down.
__
__
__