Air Discharge Chamber For Top Discharge; Installing The Unit In Heavy Snow Areas - Sanyo SPW-C706VH8 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 568
Installation space
Install the outdoor unit with a sufficient space around the
outdoor unit for operation and maintenance.
(1) Obstructions on the left side, right side and rear side
(Front side and above the unit are opened). (Fig. 2-5)
* Necessary space is required to unscrew on the rear side for
maintenance and if a suffi cient maintenance space is provided
on the rear side (40 cm), the space of over 15 cm is enough at
the right side.
(2) Obstructions on the front side and rear side (Left side, right
side and above the unit are opened). (Fig. 2-6)
* For compressor replacement, 50 cm or more is required on the
front side even when using the air discharge chamber.
(3) Obstructions on the front side and above the unit (Left side,
right side and rear side are opened). (Fig. 2-7)
In case of multiple installations
● Provide a solid base (concrete block, 10 × 40 cm beams or
equal), a minimum of 15 cm above ground level to reduce
humidity and protect the unit against possible water damage
and decreased service life. (Fig. 2-8)
● Use lug bolts or equal to bolt down unit, reducing vibration
and noise.

2-3. Air Discharge Chamber for Top Discharge

Be sure to install the air discharge chamber in the field when:
● it is difficult to keep a space of min. 1 m between the air
Fig. 2-5
● the air discharge outlet is facing a sidewalk and discharged

2-4. Installing the Unit in Heavy Snow Areas

In locations with strong wind, snow-proof ducting should
likewise be fitted and direct exposure to the wind should be
avoided as much as possible.
Fig. 2-6
■ Countermeasures against snow and wind
In regions with snow and strong wind, the following problems
may occur when the outdoor unit is not provided with a platform
and snow-proof ducting (Fig. 2-10):
a) The outdoor fan may not run and damage of the unit may be
b) There may be no airflow.
c) The tubing may freeze and burst.
30 cm
d) The condenser pressure may drop because of strong wind,
or more
Fig. 2-7
In regions with significant snowfall, the outdoor unit should
be provided with a platform and snow-proof duct.
16
Air intake
Air discharge
Air discharge
Anchor bolts
(4 pieces)
discharge outlet and an obstacle.
hot air annoys passers-by. (Fig. 2-9)
Air discharge
caused.
and the indoor unit may freeze.
Without snow-
proof ducting
(Low platform)
Air intake
Min. 15 cm
or more
Fig. 2-8
Fig. 2-9
With snow-proof
ducting
(High platform)
Fig. 2-10

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Spw-c906vh8

Tabla de contenido