Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. REMOVE FILTERS AND BOTTOM PANEL (A
Lay the hood flat on a table. Use a piece of cardboard to avoid
damaging the table or the hood.
Remove tape on filters. Remove filters from hood and set aside.
NOTE: It is recommended to start with the center one(s).
Remove bottom panel both retaining screws. Set bottom panel and screws aside.
R
ETAINING SCREWS
B
OTTOM PANEL
HD0541
6. CHOOSE THE OPENING (P5
Remove the knockout for the chosen opening (horizontal at the back of the hood or vertical on rough-in plate). See pictures below.
If using P5 blower, remove 10" wide knockout. If using P8 blower, remove either 10" or 14" wide knockout.
14"
KNOCKOUT
10"
KNOCKOUT
HD0076
Removing horizontal knockout opening on back of hood.
LL BLOWERS
HD0542
P8
AND
BLOWERS ONLY
CAUTION
7
)
1
3
HD0544
)
HD0077
Removing vertical knockout opening on rough-in plate.
2
Publicidad
Tabla de contenido
