Light Bulbs Replacement - Best UP26M Serie Manual De Instrucciones

16. REINSTALL BOTTOM PANEL AND HYBRID BAFFLE FILTERS
Remove protective plastic film covering filters before installing them.
Reinstall bottom panel using both retaining screws removed in step 5.
Reinstall filters. It is recommended to install side filters first and finish with center one(s).
 Insert the end with filter spring clip of hybrid baffle filter into the upper channel of the hood.
 Raise the other end toward the inside and insert in the grease drip rail of the hood.
Replacement filters are available from your dealer. See label inside hood for part number.
1
HD0543

17. LIGHT BULBS REPLACEMENT

This hood requires 120 V, 50 W, MR16 with GU10 base or PAR16 with GU10 base, shielded halogen lamps (included).
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a cool beam, a dichroïc lamp, a lamp not suitable for use in
recessed luminaires or identified for use in enclosed fixtures.
1. To remove lamps, gently push upwards and turn counterclockwise to
disengage bulb leads from their grooves.
NOTE: To ease removal of the bulbs, use a rubber dishwashing
glove or use suction cup tool available from Best. Contact
Best Customer Service at 1-800-558-1711 to order suction
cup tool, part no. 99526707.
2. Install the new lamps by placing the bulb leads into their grooves in
the socket.
3. Gently push upwards and turn clockwise until secure.
CAUTION
2
WARNING
!
1
HO0089
12
2 3