Warranty Conditions - Rotex GW-20 H12 Instrucciones De Instalación

11

WARRANTY CONDITIONS

The general warranty conditions of Rotex Heating Systems
GmbH apply to this product.
The warranty is void if it is determined that the faults,
damages, or undue wear are attributable to improper use or
inexpert treatment or inexpert repair, setting, installation or
maintenance, by non-certified installers, or that it was exposed to
substances with aggressive chemicals (incl. hair spray) and other
damaging substances.
The warranty also becomes void when pipes and couplings have
been applied in the installation which may cause oxygen diffusion,
or the defect is a consequence of lime scale (damaging to the unit
and installation). Surface damage as well as transport damage is
included under the warranty. The entitlement to warranty becomes
void if it cannot be proven that the CH boiler has been subjected to
maintenance by a certified installer at least once a year from the
commissioning date. The instructions for installation and use which
we provide for units must be followed in full.
Environment
If the unit is due for replacement, it can usually be taken
back by your dealer, following consultation. Should this not
be possible, consult your council for the possibilities for
recycling or environmentally friendly processing of used
materials.
Various plastics and metals were used in the manufacturing
of the unit. Furthermore, the unit contains electrical
components which belong with electronic waste.
Use as intended
The unit, as described in this documentation is intended for heating
spaces via a central heating installation and/or the supply of hot water.
Any other usage falls outside the intended use of the unit. No liability
can be accepted on damage arising from incorrect use.
54