Dell DR Serie Manual De Instrucciones página 45

NOTA: If you want to reset your login password, click Reset Password on the DR Series System Login page.
The Reset Password dialog is displayed.
The reset options displayed depend on the password reset option you configured earlier. For more information
see, Modifying Password Reseting
By default, the service tag option is displayed. In Service Tag, enter the service tag number ID for the system,
and click Reset Password to reset the system password back to its default setting (or click Cancel to return to
the DR Series System Login page).
2. In Password, type St0r@ge! and click Log in or press <Enter>.
The Customer Registration and Notification page is displayed. Before you can begin using the DR Series system
graphical user interface (GUI), you need to properly register the system with Dell. In addition, this page also allows
you to sign up for notifications about appliance alerts and system software updates. For more information, see
Registering a DR Series
3. In the Settings pane of the Customer Registration and Notification page, complete the following:
a) In Contact Name, enter a system contact name.
b) In Relay Host, enter a hostname or IP address for the relay host.
c) In Email Address, enter an email address for the contact.
d) Select Notify me of DR4000 appliance alerts to be notified about system appliance alerts.
e) Select Notify me of DR4000 software updates to be notified about system software updates.
f) Select Don't show me this again to not display the Customer Registration and Notification page again.
g) Click Confirm to have the DR Series system accept your settings (or click Skip without configuring any settings)
to proceed with initialization.
The Initial System Configuration Wizard page is displayed.
4. To start the initial system configuration process, click Yes.
The Initial Configuration — Change Administrator Password page is displayed.
NOTA: If you click No, you will bypass the initial system configuration process, and the DR Series system
Dashboard page is displayed. However, when you next log in to the DR Series system, you will be prompted to
perform the initial system configuration process again with the Initial System Configuration Wizard page is
displayed.
5. In the Settings pane of the Initial Configuration — Change Administrator Password page, complete the following:
a) In Current Password, enter the current administrator password.
b) In New Password, enter the new administrator password.
c) In Retype New Password, enter the new administrator password again to confirm it.
d) Click Next to continue with the initial configuration process (or click Back to return to the previous page, or
click Exit to close the Initial System Configuration Wizard).
The Initial Configuration — Networking page is displayed.
6. In the Settings pane of the Initial Configuration — Networking page, complete the following:
a) In Hostname, enter a hostname that meets the hostname naming convention: A-Z, a-z, 0–9, the dash special
character (-), within a maximum 19 character limit.
b) In IP Address, select the Static or DHCP mode of IP addressing, and if planning to use a Secondary DNS, enter
an IP address for the secondary domain name system.
c) In Bonding, select the Mode choice from the drop-down list (ALB or 802.3ad).
Dell recommends that you verify the system can accept your bonding selection type. The connection will be
lost unless it is correctly configured. For more information, see
d) In Bonding, enter the MTU value for the maximum transmission unit (the MTU accepts values between 512 and
9000). For more information, see
e) In Active Directory, enter a fully qualified domain name for the Active Directory Services (ADS) domain in
Domain Name (FQDN), enter an organization name in Org Unit, enter a valid ADS username in Username, and
enter a valid ADS password in Password.
Options.
System.
Configuring Networking
Configuring Networking
Settings.
Settings.
45