Technical Information - Electrolux EWF 1086 GDW Manual De Instrucciones

22 www.electrolux.com
Problem
The appliance fills with
water and drain imme-
diately.
The washing results
are not satisfactory.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Service.

13. TECHNICAL INFORMATION

Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
Water supply pressure
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible solution
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too
small.
Make sure that the drain hose is in the correct position.
The hose may be too low.
Increase the detergent quantity or use a different deter-
gent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
600 / 850 / 605 mm
1200 rpm (EWF1086GDW)
1400 rpm (EWF1286GDW)
640 mm
230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg