Manufacturer's Warranty; Fcc Statement (Applicable In Us) / Ic Statement (Applicable In Canada) - Hilti PR 30-HVS A12 Manual De Instrucciones

Trouble or fault
Invalid entry.
The command is not possi-
ble; no reaction.
Surveillance mode is active.
Sleep mode is active.
Low battery in the rotating
laser.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

FCC statement (applicable in US) / IC statement (applicable in Canada)

The product complies with part 15 of the FCC Rules and RSS­210 of the IC.
Operation is subject to the following two conditions:
18 English
Printed: 24.04.2018 | Doc-Nr: PUB / 5314337 / 000 / 01
Possible cause
Invalid entry; the command is not
possible.
Valid entry, but the tool doesn't
react.
Surveillance mode is active. Re-
alignment not possible.
The tool is in sleep mode.
Low battery in the rotating laser.
Action to be taken
▶ Make a valid entry again. Read
the operating instructions.
▶ Check that all devices are
switched on.
▶ Check that all devices are within
direct range.
▶ Repeat the entry.
▶ Check the positions of the
rotating laser and the PRA 30
laser receiver.
▶ Check that all devices are within
direct range.
▶ Restart automatic alignment.
▶ Activate / deactivate sleep
mode. → page 12
▶ Charge the battery.
2134493
*2134493*