On The Product; Product Information; General Safety Measures - Hilti PR 30-HVS A12 Manual De Instrucciones

1.3

On the product

Laser information
Laser class 2 based on standard IEC60825-1 / EN60825-1:2007 and compliant with CFR
21 § 1040 (Laser Notice 50).
Do not look straight into the laser beam.
1.4

Product information

products are designed for professional users and only trained, authorized personnel are permitted
to operate, service and maintain the products. This personnel must be specifically informed about the
possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Rotating laser
Generation
Serial no.
1.5 Type approval test
2 Safety
2.1 Basic information concerning safety
Read all safety instructions and other instructions. Failure to observe the safety instructions and other
instructions may result in electric shock, fire and/or serious injury.
Retain all safety precautions and instructions for future reference. The term "electric tool" used in the
safety instructions refers to your mains-operated (corded) electric tool or battery-operated (cordless) electric
tool.
2.2

General safety measures

▶ Stay alert, watch what you are doing and use common sense when operating a power tool. Do not
use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of
inattention while operating the power tool can result in serious personal injury.
▶ Do not render safety devices ineffective and do not remove information and warning notices.
▶ Keep children well away from laser devices.
▶ Laser radiation in excess of Class 2 may be emitted if the device is opened without following the correct
procedures. Have the device repaired only by Hilti Service.
▶ Project laser beams well above or well below eye height.
▶ Take the influences of the surrounding area into account. Do not use the device where there is a
risk of fire or explosion.
▶ Statement in accordance with FCC §15.21: Changes or modifications not expressly approved by Hilti
can restrict the user's authorization to operate the equipment.
▶ You must check the accuracy of the device after it has been dropped or subjected to other
mechanical stresses.
▶ When the device is brought into a warm environment from very cold conditions, or vice-versa,
allow it to become acclimatized before use.
▶ When using adapters or accessories, make sure that the equipment is securely mounted.
▶ Keep the laser aperture clean to avoid measurement errors.
▶ The device is designed for the tough conditions of jobsite use, but as with other optical and
electronic instruments (e.g. binoculars, spectacles, cameras) it must be handled with care.
▶ The device is protected to prevent the ingress of moisture, but you must always wipe it dry before
stowing it in the transport container.
▶ Check the device before using it for important measuring work.
▶ Repeatedly check accuracy while using the device.
2 English
Printed: 24.04.2018 | Doc-Nr: PUB / 5314337 / 000 / 01
PR 30-HVS A12 | PRA 30
02
2134493
*2134493*