Manual Selection - Shure PSM 300 Guia Del Usuario

Creating a Wireless Connection Between Receivers and Transmitters (Sync)
To pass audio from the transmitter to the receiver, both must be tuned to the same frequency. The easiest way to configure the system is to use the
automatic sync feature. This transfers group and channel settings with a press of a button. Based on your system configuration, use one of the following
processes to sync the components:
Single Transmitter and Receiver
The following sync procedure should be used with a setup that consists of a single transmitter
and receiver, unless a group/channel setting has been assigned prior to a performance.
PSM300 Transmitter P3T
sync
Sync from receiver to transmitter:
1. Perform a scan on the receiver (see "Scanning for the Best Open Channel" for best practices).
2. Align the IR windows on the receiver and transmitter. The windows should be 6-11 cm apart.
3. Press the SYNC button on the transmitter while the blue RF LED on the receiver is flashing.
4. The Transmitter displays SYNC when the sync is successful. The arrow between
Rx (receiver) and Tx (transmitter) shows the direction of the sync.
Note: When the RF LED on the receiver is flashing after performing a scan, the receiver sends its
frequency setting to the transmitter. After it stops flashing, pressing
the transmitter to the receiver.
Single Transmitter and Multiple Receivers
The following sync procedure should be used with a setup that consists of a single transmitter
with multiple receivers, or if a specific group/channel setting has been assigned to the transmitter
prior to a performance.
PSM300 Transmitter P3T
group channel power
(A-Y) (0-9)
sync
Sync from transmitter to receivers:
1. Sync the first receiver to the transmitter using the sync procedure
for a single receiver. Performing a scan and using the resulting
group and channel from the receiver is recommended.
2. Set additional receivers to the transmitter frequency (one at a time) using IR sync:
• Align the IR windows on the receiver and transmitter and press SYNC.
• The receiver LED should not be flashing when pressing SYNC.
Note:
Receivers can also be manually tuned to the transmitter if an IR sync is not practical.
Multiple Transmitters and Multiple Receivers
1. Set up the first transmitter and all associated receivers according to the appropriate sync procedure. Keep the
transmitter and all receivers from this first system powered on when setting up additional systems.
2. Set up each additional system using the appropriate sync process. Always leave each new system on before setting up an additional one.

Manual Selection

If frequencies have been planned ahead of time, the group and channel can be set manually without performing a scan. Refer to the frequency table at
the end of this user guide to identify frequencies for each group/channel setting.
To select group/channel settings on the receiver and transmitter:
1. Press GROUP to scroll through group settings.
2. Press CHANNEL to scroll through channel settings within the selected group.
group channel power
(A-Y) (0-9)
SYNC sends the frequency setting from
9
Align the IR windows to sync the receiver
and transmitter
PSM300 Transmitter P3T
input
sync
Pressing the SYNC button transfers group/
channel data
group channel power
(1-9) (1-F)