Shure PSM 300 Guia Del Usuario página 7

Multiple Transmitters with Separate Mixes
When several performers in a group have different monitoring
requirements, multiple PSM300 systems may be used
simultaneously to send different mixes through each transmitter.
This setup requires a mixer with two monitor/auxiliary outputs for
each transmitter.
Tip: To simplify setup in applications that involve multiple
transmitters, Shure offers the P3AC antenna and power
distribution system, which supplies up to four PSM transmitters
with power and RF from a single source.
P3T
PSM300 Transmitter P3T
input sync power
group channel
(1-9) (1-F)
Mix 1
P3T
PSM300 Transmitter P3T
input power
sync group channel
(1-9) (1-F)
Mix 2
Signal Routing to External Devices
(Combination Systems)
The LOOP outputs pass audio to an external device, such as other
personal monitoring systems, recording devices, or stage monitors. The
signal at the LOOP outputs is identical to the signal coming from the
mixer, and is not affected by the transmitter volume or input sensitivity
(line/aux) settings. This makes the LOOP outputs particularly useful
when using a mixer that has one or two monitor/auxiliary sends.
Using the PSM300 simultaneously with Loudspeakers:
A combination monitoring system can be used, where some of the
performers are using the PSM300 wireless system and others are
listening through loudspeakers on stage.
Note: If using passive stage monitors, the P3T outputs must be
connected to an amplifier. Active (amplified) speakers can be
connected directly to the P3T outputs.
Using the PSM300 Combined with Other Wireless
Monitoring Systems
In a scenario where two performers have their own wireless monitoring
systems (one Shure PSM300 system and one third-party system, for
example), the PSM300 can pass the signal from the mixer on to the
second monitoring system.
POWER MONO/STEREO-MX LINE/AUX L - LOOP OUT - R
P3T
Mixer Auxiliary/Monitor Outputs
7
Stage Monitor Loudspeaker
Amplifier
Transmitter LOOP Outputs
LEFT/CH.1 IN RIGHT/CH.2 IN ANTENNA